Parameter changed that requires a restart of the drive The "First Setup" (FSU) was not run at all or not completed. Value in additional error information shows the Modbus register address of the parameter where the initialization error was detected.īasic configuration of drive required after factory setting System error detected: No bootloader availableĬonfiguration error detected (additional info=Modbus register address)Įrror detected during parameter check (for example, reference velocity value for operating mode Profile Position is greater than maximum permissible velocity of drive). The write access level expert is required.Ĭommand not permissible while power stage is activeĬommand not permissible while the power stage is enabled (operating state Operation Enabled or Quick Stop Active).ĭisable the power stage and repeat the command.Īccess occupied by another channel (for example: Commissioning software is active and fieldbus access was tried at the same time).įile cannot be uploaded: Incorrect file IDĭata stored after a power outage is invalid
Parameter only accessible at expert level. Write access denied (no access authorization) Write only to parameters that are not read-only. Parameter write not permissible (READ only) The entered value must be within the permissible value range.Įrror detected by parameter management: Parameter (index) does not exist.Įrror detected by parameter management: Parameter (subindex) does not exist. The value entered was outside of the permissible value range for this parameter.
0 kommentar(er)
